Sears 385.1884180 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Prepare the Bobbin
o To Remove the Bobbin from the Machine
SECTION 2. PREPARE YOUR MACHINE FOR SEWING
1.
Gently push down on the bobbin cover plate and slide
It towards you,
2.
Set aside.
3.
Lift out the bobbin, as shown.
o Wind the Bobbin
1.
Put your spool of thread onto spool pin, with the thread winding in the direction
shown.
2.
Pull the dutch away from the machine to stop the iieedle from moving while you
winding the bobbin.
3.
Draw thread from spool through bobbin winder tension disc as shown.
4.
Place the threaded bobbin on the bobbin winding spindle so that the thread comes
out on top.
5.
Posh the bobbin winder spindle to the right until it clicks.
6.
Holding onto end of thread, depress the foot control.
7.
When the bobbin is slightly filled, stop the machine and clip the thread coming from
the bobbin.
8.
Slowly start the machine again and wind the thread until the bobbin stops.
9.
Push the bobbin winder spindle to the left and clip the thread.
10.
Remove the bobbin.
11.
Push in the clutch for normal sewing operation.
16