Sears 385.1884180 - Manual (Page 52)

SECTiON 3. LEARN THE STITCHES
Buttonhole Making (Continued)
b.
c.
Pull catch toward you while slidiny the template until the button­
hole size you have chosen ts at the setting mark.
insert gear of base plate into slot of temptate and fit guide block
into the center of the gmde slot.
b. Adjust position of gear so it is aligned with the starting point of
template.
The lever can be used to change gear position.
c. Puli the bobbin thread up through guide slot by turning the hand wheel
toward you while holding top thread.
d. Place the bobbin and top threads to the left side of guide plate.
Leave 3 to 4 inches of thread.
50