Sears 385. 17526 - Manual (Page 14)

SECTION 2. PREPARE THE MACHINE FOR SEWING
Know What the Presser Feet Will Do (Continued)
• Change the Presser Foot (Continued) * Presser Foot Types
Zigzag Foot
To Snap On
1. Place the presser toot so the
horizontal pin on the toot lies just
under the groove of the toot holder.
2. Lower the presser foot holder to
lock the presser foot in place.
NOTE; If you do not hear the presser
loot snap in place, press
down on the presser toot
holder firmly until you hear
the snap.
stitching.
Uses: Zigzag stitching (see page 36).
Bar tacking (see page 38).
Button sewing (see page 40),
Overcasting stitch (see page 41),
Blind hemming (see page 42),
Lace work (se page 43),
Three-step zigzag (see page ¿4),
Box stitching (see page 45).
Two-point shell stitching
(see page 46).
Fagoting (see page 4i),
Two-point box stitch (see page 47),
Overedging stitch (see page 47),
Rick-rack stretch (see page
Overcast stretch (see page 50),
Smoking (see page 50),
Elastic stretch (see page 51),
Stretch patching (see page 62),
Herring bone stretch (see page 53),
Decorative stretch patterns
(see page 53),
Twin needle stretching (see page fit).
Straight Foot
Use this exclusively lor straight stitching
using center needle position only.
Uses: Straight stitching (see page 31),
Topstitching (see page 32),
Straight stretch (see page 49).
12