Care free stitching depends on the big kenmore, And the little, Needles shuttle threading needle – Sears 385. 17526 User Manual
Page 73: I£r v threading, Feeding oiling tension shuttle, Important
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CARE FREE STITCHING
depends on the
BIG
Kenmore
S) ffi
1ÍÍ:
NEEDLES
SHUTTLE
THREADING
NEEDLE
Make certain your needle
IS
correctly inserted with
flat side away from you.
Be sure needle is not blunt
or bent.
( ‘ i - >
i£r V THREADING
’’X' J THREAD CAN TANGLE AND SNAP without being seen. It your
ij thread breaks, unthread and then RETHREAD the machine, both lop
-imsa*-
bottom thread.
BOTTOM THREADING
1. Insert bobbin into shuttle making sure bobbin
rotates counter clockwise.
2. Pull thread through slot (Aj and then to the iait.
Pull thread through rtolch (B) and leave thread
about 4 inches tong.
Y)
TOP THREADING
Maks sure there is no slack or
snags In She thread. Use the
type ol thread and size needle
recommended in your instruc
tion book.
and the
LITTLE
FEEDING
OILING
TENSION
SHUTTLE
Clean in and around the shullle and lead
dogs to remove accumulated dust and tint
which may cause NOISE OR JAMMING.
FEEDING
(MATERIAL DOESN'T
FEED PROPERLY)
I
OILING
Open face cover plate and oil 2 points as
shown below at least once a year. One or
two drops ol oil is surticleni. Remove
excess oB. otherwise it may stain fabric
In case machine !s trot used tor an
extended time, oillt before sewing. Lsi
good quality sewing machine oil.
COMPLETING THREADING
Hold top thread loosely in lelt hand and ratals
handwheel toward you one complete turn. Bring
bottom thread up and next, pull lop and bottom
threads under and to the back ol prasser toot.
'~,jn
TENSION
1 1
• i Compare your straight stitching with the lllustralions. If it looks like either
) I.' of the lop two, correct the thread tension dial as shown.
BE SURE TO NOTE YOUR PRESENT SETTING BEFORE YOU START
ADJUSTING.
m
Oecfease lension
Increase tension
Upper thread too loose
Coifeci stitching
IMPORTANT
For your safety an important new feature has been incorporated In this machine.
The light/power switch provides electric cuítent for the motor as well as the light
in order to operate the machine this switch must be on.
If you are interrupted while sewing and must leave the machine unattended, just
turn off the light/power switch and the machine can not be started accidentally by
pressing on the fool control, this feature afso applies when the machine is in
storage.
The toot control is used to vary the machine speed from zero to high.