Prepare the top thread a thread the needle – Sears 385. 17526 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 2. PREPARE THE MACHINE FOR SEWING
Prepare the Top Thread
a Thread the Needle
The numbered steps above tollow the numbers
on the illustrations.
Dotted lines show places where the thread
loops and then is pulled tight.
Raise take-up lever to its highest position by turning hand wheel toward you.
Raise presser tool lever.
Place the spool on the spool prn as shown, with thread coming from the back of the spool.
11. Draw thread into thread guide using both hands.
2, While holding thread near spool, draw thread down into the tension area and then around the
check spring holder,
3, Firmly draw thread up and through take-up lever from right to left.
4, Draw thread down and slip it through the thread guide.
5, Thread then is slipped into needle bar thread guide.
6, Thread needle from front to back.
NOTE; Cut the end of the thread with sharp scissors for easier needle threading.
19