Sears 385. 17526 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
o Bobbin Wind
SECTION 2. PREPARE THE MACHINE FOR SEWING
® Pull {he clutch knob away from the machine to disengage clutch.
(2) Draw the thread from the spool.
(3) Guide the thread around the bobbin winder thread guide.
® Insert the thread through the hole In the bobbin, threading from the inside to the outside.
(5) Put the bobbin on the bobbin winding spindle, and push it to the right
(6) With the free end ol the thread held in your hand, depress the toot control.
@ Stop the machine when it has made a tew turns, and cut the thread close to the bobbin.
Depress the toot control again. When the bobbin is fully wound, It will stop automatically.
CD
Return the bobbin winder to its original position by moving the spindle to the left, and cut the thread as
shown.
(D
Push In the clutch knob to engage clutch.
* The machine will not sew until the clutch knob is pushed in.
NOTE; The bobbin winder stopper can be adjusted for
the amount of thread needed on the bobbin
(example 1/2 full or full etc.). To make the
adjustment use your large screw driver and
loosen the screw one turn or less. This will
allow you to adjust the position of bobbin
winder stopper. Do not take screw all the
wayout
17