Instructions for cabinet installation – SINGER WS1112 User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BACK OFF
SET SCREW
TO CLEAR
HINGE HOLE
X
HEAD HINGE SET
SCREWS
LIFT FLAP
TO LOWER
HEAD INTO
CABINET
INSTRUCTIONS FOR CABINET INSTALLATION
1.
Loosen head hinge set screws until
head hinge hole is clear.
2.
Tilt head hinge tongues up and back
as far as they will go.
3.
Carefully slip head onto head hinges
making sure tongues are inserted as
far as they can go into head hinge
holes.
4.
Allow the head to rest in its tilted
back position.
5.
Tighten both set screws securely with
screw driver.
6.
Plug
electrical
leads
into
sockets
located inside cabinet. Cord identified
with
"motor"
tag
must
be
plugged
into socket marked "motor". Untagged
cord goes to "light" socket.
7. If your machine begins to run automatically
without the use of the knee, control, this
indicates that the motor plug and light
plug are in the wrong sockets and should
be reversed.
HEAD HINGE
HOLES
HEAD HINGES
HINT; STRETCH
A RUBBER BAND
ACROSS THE TWO
HINGES TO HELP
HOLD THEM UP.
RIGHT WHILE
MOUNTING THE
SEWING HEAD.