Winding the bobbin, Inserting the needle winding the bobbin – SINGER WS1112 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Fig. 2
See Fig. 2. Raise the needle bar ® to its highest point, turning
hand wheel toward you by hand. Then loosen the needle clamp
screw (D and the needle can be inserted into clamp ®.
Place needle (Fig.3, FLAT SIED TO RIGHT) in the needle ckmp
and push it upward as far as it will go into the needle clamp ho e,
tightening the needle clamp screw securely with a screw driver.
After changing the needle, make one complete revolution of the
hand wheel by hand to be sure the needle is in the correct position.
INSERTING THE NEEDLE
WINDING THE BOBBIN
Fig. 3
Disenaaae the hand wheel C®, Fig. 4) from the stitching
Disengag
_i„trh C(i) Fig 4) toward you or counter
mechanism by turnmg the clutch CU< y
lead
oloctwi^. ..pool of to...!
»“ol
thread around one set of arm thread guide (®, Fig. 4). Run en
thread through a hole in the bobbin edge and place
spindle of bobbin winder (®, Fig. 4) fitting the ^°tch^ bobbm
over small pin on spindle. Push bobbin
^^wly
against bobbin. Hold thread end loosely and start machine slo y
Bobbin will stop winding when it is filled.
Tu^ clutch away To reengage stitching mechanism turn clutch
(®,Fig.4) clockwise.