Upper threading – SINGER WS1112 User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

UPPER THREADING

Turn hand wheel toward you to raise the

take-up lever and needle to their highest position.

Place spool of thread on spool pin and lead

thread through top plate thread guide® and®.

Down and between tension discs® from right

to left.

Up and over the tension spring® then down

under the thread bar®

Up though thread bar guide® and into take-up

leverr® from right to left.

Down through thread bar guide® again and

into face plate guide® and needle clamp guide®.

Thread needle from left to right pulling three

to four inches of thread through needle.

Hold the end of the upper thread loosey and

turn hand wheel toward you until the needle goes
all the way down and comes back up bringing with
it the bottom or bobbin case thread.

Place both threads

(upper and lower)

imder the slot of the
Presser foot and place
toward the back of the

machine, leaving both
threads three to four

inches long.

Fig, 10

Advertising