SINGER W221N User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
UPPER THREADING
CHECK
SPRING
1. Turn the hand wheel toward ;
you to raise the take-up lever
to its highest position.
2. Place a spool of thread on the
spool pin.
3. Lead the thread through the
top thread guides.
. 4. Down and between the tension
discs, from right to left.
5. Draw the thread up through the
chedc-spring and with a slig t
tug into the hook.
6. Up and through the eye of take-
up level from right to left.
7 Lead thread down through the
■ thread guide at the bottom of
the threading
tlot.theo,
through
the needle bar thread guide from
the back.
8.
Thread
the
needle
FROM
FRONT TO BACK, drawing it
through about 3 or 4 inches.
Hold the end of the upper
thread
loosely
and
turn
the
hand wheel toward you unti
the needle goes all the way
down and comes bade up. A
thread loop will form over the
upper thread which then can be
pulled out straight. Place ^t
thread ends under presser oo
and draw toward the back o
the machine, leaving both
threads
three
or
four
mchM
long.
-13-