Embroidery – SINGER W221N User Manual
Page 41
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
N e e d l e
T h r e a d
N o . 9
1 2 0 - 1 0 0
N o . 1 1
1 0 0 - 8 0
N o , 1 4
6 0 - 5 0
EMBROIDERY
Set stitch length at "0”
Remove foot, and holder screw.
To avoid lower thread being
pulled up, reduce upper thread
tension.
For
good
embroidery,
it
is
important to use correct needles
and thread.
Use thin embroidery silk for
upper thread and a thinner silk
of same kind and color for
lower thread.
Trace your design on material
and center it in embroidery hoop.
Make sure material is taut.
Pull out lower thread by turning
hand wheel towards you while
holding upper thread lightly.
Lower presser foot lifter.
Hold both threads and start
sewing along outline of design
with satin stitch.
Continue sewing guiding hoop
by hand.
To finish filling, sew several
stitches with zigzag width at 0.
Lay typewriting paper underneath
when embroidering sheer fabric.
-38-
iaiSssssfSi'flssS