Maytag MC2 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
For added personal safety, when possible, it is suggested that a separate ground wire
(no. 18 minimum) be connected from the ground connection of the dryer to a grounded cold water
pipe. DO NOT ground to a ^as pine.
I NOTE: For 100 lb. model, a no. 12 minimum separate ground wire should be used.
The grounded cold water pipe must have metal to metal connection all the way to electrical ground.
If there are any non-metallic interruptions, such as, a meter, pump, plastic, rubber or other
insulating connectors, they must be jumped with no. 4 copper wire and securely clamped to bare
metal at both ends.
IMPORTANT: For personal safety and proper operation, the dryer must be grounded.
4. Electrical Connections
A wiring diagram is located on the back side of the control (service) door for connection data.
Single Phase Hookup
On the single-phase dryers, the electrical input connection is made to the three connection leads (LI,
L2 or N and ground) extending out of the junction box located at the upper left rear of the dryer.
Single-Phase Electrical Connection Leads
Black
White
Oreen
+
-
Psitive
Neutral
Ground
(LI)
(L2)
(CMD)
plioloOOhS
10