Section iv, 100 lb. install ation information, A. location of the dryer – Maytag MC2 User Manual
Page 20: 100 lb. installation information
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION IV
100 lb. INSTALL ATION INFORMATION
A. LOCATION OF THE DRYER
If more headroom is needed when moving the dryer into position, the top console may be removed.
(Figure 1)
1. Disconnect the ground wire (A) at the rear of the dryer. (Figure 3)
2. Remove the six (6) nuts (B) holding the console to the base. (Figure 2)
3. Open the control door and disconnect the white 15-pin plug (C) located at the bottom of the control
box. (Figures 2 and 3)
4. Lift the console off the base. (Figure 3)
To level the dryer, place 4-inch square metal shims (D) or other suitable material under the base pads.
(Figure 3)
FRONT VIEW - Figure 1
TOP (CUT AWAY VIEW) - Figure 2
16