Instructions for installation (cont'd) – Maytag HE21250PC User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Instructions for Installation (cont'd)
THERMOSTAT REMOVAL (cont'd)
10. Carefully disconnect wiring harness terminal connector
from back of riiennostat.
11. Remove the wall plate from the water heater by unscrewing
the two mounting screws. The wall plate will be installed at
the selected location in Steps 28 and 29.
12. Loosen each screw in the terminal connector and remove the
wire ends. The terminal connector will be installed at the
selected remote location in Step 31.
13. Press the end of the thermostat cable back into the insulating
bushing. No other connections will be made to this end of
14. Close and latch outer door.
REMOTE THERMOSTAT WIRING ATWATER HEATER
IS. Remove mounting screw and right junction box cover. Also
lift up and remove black plug on left junction box cover.