SINGER W815 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
22. ZIPPER SEWING
1 Release the thumb screw on rear side of foot. Lower needle into the
side notch of the foot and check position of the foot to avoid needle
strike the foot. Fasten thumb screw to the lock make sure that the foot
is in DOSitlOn.
,
. ,,
___
2. Fold edge of the material by %" and place zipper under the folded portion
of the material where you wish to attach the zipper.
3 Stitch close to the edge of the zipper foot along zipper teeth.
4
' To sew on the opposite side of the zipper, loosen thumb screw and slide
tne foot over and sew in the same way.
23. FELLING
Us-the hemmer foot
for
doing felling and
proceed in the following manner
V Lav two pieces of cloth one on too of the other with their RIGHT sides facing
each other. The right edge of the bottom piece must extend about ¡^inch beyon
the right edge of the top piece. See Fig. 26
2 Sew both pieces of cloth together using the hemmer foot like a regular presser
'oot. Use the right edge of long toe of hemmer foot to guide the bottom piece
of material while the left edge of the same toe serves as a gu
1
de for the top piece
of material. Fig. 26 shows this aetaii.
3. Open and spread out material and put back on machine nght sides downward.
Make sewn edges of material stand up.
Fold
over
the edges to the left and insert them into the scroll of the hemmer foot.
Sew as you would do ordinary hemming. Use left edge of long toe of hemmer
-Out
as
guide,
having original seam run alongside of it (Fig. 27!
Fig 25
TOP PI CCE
BOTTOM PUCE-
Fig 26
flPST
FOID
2 0
-
Fig 27