SINGER W815 User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6. THREADING THE MACHINE
Place a spool of thread on spool pin and raise the take-up
lever to its highest point Refer to(Fig. 8).
Pull thread through slot of upper thread guide (1) down
through tension discusi2)up into thread check spring (3) and
(4) and on up into the eye of the take-up lever (5) from right
Return thread through middle thread guide ¡6) down through
lower guide (7j and into needle bar thread guide (8).
Thread needle from left to right, pulling about four inches
of thread through needle.
7. SETTING THE NEEDLE
1. Turn the balance wheel towards you, raising needle bar
to its highest position, and loosen the needle clamp screw.
2. Hold the needle in the left hand with the point down
and insert the needle up into the needle clamp as far
as it will go with its flat surface to the right then retight
en the clamp screw (Fig. 9).