Monogramming and embroidering with embroidery hoop, Preparation for monogramming and embroidering, Stitch – SINGER 3810 User Manual
Page 56
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
□ Monogramming and embroidering with embroidery hoop*
stitch
display
Drop the feed dogs (Note; Stitch length cannot be controlled
with dial)
(see item #24 on page #3)
• Set the machine as illustrated:
• Remove the presser foot and the presser foot holder.
• Lower presser foot lever before starting to sew.
• Adjust the stitch width according to the size of lettering or
design.
Stitch width dial
Preparation for Monogramming and
Embroidering*
• Draw the desired lettering or design on the right side of the
fabric.
• Stretch the fabric between embroidery hoop as firmly as
possible.
• Place the fabric under the needle. Make sure the presser
foot bar is down in its lowest position.
• Turn the handwheel towards you to bring up the lower
thread through the fabric. Sew a few securing stitches at the
starting point.
• Hold the hoop with thumb and forefingers of both hands.
• Coordinate sewing speed and movement of hoop.
(For 3 dial 25 stitch model)
52