The evenfeed foot optional accessory – SINGER 3810 User Manual
Page 59
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
□ The evenfeed foot optional accessory
* The evenfeed foot is an optional accessory not supplied with this
machine.
Always try to sew first without the evenfeed foot accessory which
should be used only when necessary.
It is easier to guide the fabric and you have a better view of the
seam when using the standard, regular foot on your machine. Your
sewing machine offers excellent stitch quality on a wide range of
fabrics from delicate chiffons to multiple layers of denim.
The Evenfeed Foot accessory equalizes the feeding of the upper
and lower layers of fabric and improves the matching of plaids,
stripes and patterns. It also helps to prevent uneven feeding of very
difficult fabrics.
1) Lift the presser foot lifter to raise the presser foot bar (1).
2) Remove the presser foot holder by unscrewing
(counterclockwise) the presser bar attaching screw (2).
3) Attach the Evenfeed Foot to the machine as follows:
i)
The arm (3) should fit above the needle screw and clamp
(4).
ii) Slide the plastic attaching head (5) from your left to right so
that it is fitted into the presser foot bar.
iii) Lower the presser foot bar (1)
iv) Replace and tighten (clockwise) the presser bar attaching
screw (2).
4)
Make sure both the needle screw (4) and the presser bar
attaching screw (2) are tightly secured.
5) Draw the bobbin thread up and place both the bobbin thread
and the needle thread behind the evenfeed foot attachment.
Attaching head (5)
Presser foot bar (1)
55