Embroidering with a hoop, Darning – SINGER W1365 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
18
EMBROIDERING WITH A HOOP
It is easy to follov/ a stamped design or to work
free hand when embroidering or monogramming.
(See Fig. 27). Release the pressure from the foot
by pressing down the snap look on the automatic
darner. Turn drop feed knob to DOWN position
(see Fig. 19).
Stretch the fabric in an embroidery hoop, and
place under the needle after removing the presser
foot. Set the stitch width at the size you prefer and
lower the presser bar lifter. Then operate the machine at a rather high speed
the hoop slowly with both hands. Work carefully and be sure to keep fing
of the needle.
'ig. 27
while
IflOvi
mg
Si'S out of tha
Path
DARNING
Release pressure from foot and drop feed as directed above.
Place fabric to be mended under foot, and stitch around hole, moving the fabric f’
and slowly in any direction. To fill in the hole, stitch from center outward,
completing
stitching in fabric.