SINGER W1365 User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Clean the shuttle race, the shuttle, and shuttle race cover by removing all threads, Imt, etc.
Apply a drop of oil with finger tip to outer edge of shuttle,
the cleaning has been completed, proceed as follows to replace the shuttle assem ^.
Turn the balance wheel until the needle reaches its highest position.
Place shuttle body, ( D i , against shuttle driver and adjust into position.
Replace shuttle race cover, i C , , fitting pin at lower edge into notch, and lock mti.
position with shuttle race cover clamps, i B , , making certain the clamps have been
snapped securely into position.
Put bobbin into the bobbin case.
^ u v i
Put the bobbin case into the shuttle race, fitting tongue into notch P oi race
2 Package of needles
3 Bobbins (3)
4 Felt Washers
(for spool pins)
5 Needle Plate for
Small Screw Driver
7 Large Screw Driver
9 Cloth Guide
10 Thumb Screw
11 Button Sewing Foot
12 Buttonhole Foot
13 Presser Foot for
14 Small Hemmer Foot