SINGER W1365 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PLACING BOBBIN CASE IN SHUTTLE
Open hinged cover plate left of the needle.
(See 11, Fig. li Hold the bobbin case latch, (D;,
Fig. 9, between the thumb and forefinger of the left
hand, with at least three inches of thread running
from the top of the bobbin case to the right. Insert
and center the bobbin case on the stud of the shuttle
body, ( C ) . Be sure
'
the bobbin
case
finger, ' E ; , enters
the shuttle
race
notch, (A).
Press
the
bobbin
case iB' into the
shuttle
as
far
as
possible until latch
catches on
the
center post of the
Fig. 9
shuttle.
THEN release the bobbin case latch, ( D : .
Press bobbin case again after latch has been re
leased to make sure the bobbin case is locked
securely in place. Close the cover plate.
Fig. 10