Button sewing foot, Thread shank – SINGER 431 User Manual
Page 54
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
BUTTON SEWING FOOT
Set Lever at 4. The needle should then enter into
the right hole of the button. Take approximately
six zigzag stitches in this position. End at the left
side.
To fasten stitching, adjust to number 1 Stitch
Width setting and take approximately three stitches.
THREAD SHANK
In order to form a shank, stitching is worked
over a regular machine needle. Position button and
lower button foot. Place needle in the groove of
the .foot so t];ie point enters the hole.
A larger shank results when the heavy end of
the needle is utilized.
52
Advertising