SINGER W671 - Manual (Page 18)

Hold the hoop closely on the machine bed with both hands, press the mtiterial
with your left forefinger in the vicinity of the needle. This will help in holding
down the material and will prevent the machine from making skipped stitches.
Manipulate work carefully and be sure to keep fingers out of the path of the
needles.
Adjust thread tensions for the best appearance of embroidery work and slightly
increase the bobbin thread tension to avoid the lower thread from being pulled up.
Hemming
in an embroidery hoop. (Fig. 26^
Raise the needle to its highest point.
Raise the presser bar, remove the
regular presser foot, and attach hem­
mer foot.
(1) Fold over the edge of the fabric
approximately 1 8 inch wide, then
fold it over again in the same
way for a length of about 2 inches.
Insert this folded end into the
spiral formed opening (scroll) of
the hemmer foot. fFig. 27)
Move the fabric back and forth until the hem forms itself in the scroll.
(2) Pull the fabric toward you until the beginning of the hem is just below the
needle.
(3) Guide the fabric into the hemmer foot while proceeding.
(Pig. 27)
17