Preparing to sew to remove the bobbin case – SINGER W671 User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

PREPARING TO SEW

To remove the Bobbin Case

BOBBIN CASE FrNGER

SUDE PLATE

Turn the hand wheel toward you until

the needle bar is at its highest point.

Open the slide plate in the bed of the

machine so that bobbin case can be

reached. (Fig. 3)

Insert

the

thumb

and

forefiinger

to

open the latch and withdraw the bobbin

case.

While the latch is held open the bobbin

is retained in the bobbin case and will

not drop out.

(Fig. 3)

On releasing the latch and turning the bobbin case downward, the bobbin will

drop out.

The bobbin case must never be removed when the needle bar is in the lower

position.

Neither should a bent needle be used, as it is liable to damage the bobbin case

or the shuttle.

To wind the Bobbin

Disconnect the hand wneel by holding it in the left hand, while turning the stop

motion screw over toward you with the right hand, as shown in Fig. 4.

Wind the free end of the thread several times round the bobbin and press it oniu

the spindie (.4.), passing the thread through the tension bracket (B).

Press the push-button (C) until the latch fits securely into the bobbin. When the

Advertising