SINGER W671 - Manual (Page 9)

between the tension discs from the back, up over the tension thread guard (4)
from behind, down into the hook of the take-up spring. (t>t, up and through the
hole in the end of the take-up lever (6 .-. down through the face plate thread guide
(7 and into the wire thread guide (8), at the lower end of the needle bar; then
from left to right through the eye of the needle (9 .
Draw about four inches of thread through the eye of the needle with which to
commence sewing. (Fig. 12) .
To change the Needle Plate
Raise the needle to its highest point by turning the hand wheel, and raise the
presser foot by lifting the presser bar lifter.
Move the slide plate to the left and lift the needle plate out, as shown in Fig. 13.
Place another needle plate on the guide
screws and press it down.
Note : There are four different needle
plates for various purposes.
Needle plate for zigzag stitch,
i regular).
Needle plate for straight stitch.
Two needle plates for embroidery.
(Fig. 13)
To change the Presser Foot
Raise the needle to its highest point, and raise the presser foot.
Loosen the thumb screw and remove the presser foot.
Attach another presser foot and tighten the thumb screw.
Note : There are six feet for different purposes.
8