Replacing presser foot with shank (h) (k), Attaching darning and embroidery foot (g), Attaching feed cover (f) – SINGER 9124 User Manual
Page 7: Changing the needle plate (a) (c), Replacing presser foot with shank, Attaching darning and embroidery foot, Attaching feed cover, Changing the needle plate
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Your machine comes with the General Purpose Presser Foot (B) already attached. You
can easily change to any one of the other presser feet which snap onto a common shank
by following the directions below.
CHANGING THE PRESSER FOOT (B) (D) (E) (J) (L)
REPLACING PRESSER FOOT WITH SHANK (H) (K)
Presser feet with built-in shanks can be replaced as follows:
Turn machine off.
Raise needle to its highest position by
turning hand wheel toward you.
Raise presser foot using presser foot
lifter in back of machine.
Push toe of presser foot (1) up, until it
snaps off the shank (2).
• Raise needle and presser foot.
•
Loosen presser foot screw (1) and
remove presser foot with shank (2),
guiding it toward you and to the right.
• To replace presser foot with shank,
hook shank around the presser bar
and tighten presser foot screw.
ATTACHING DARNING AND EMBROIDERY FOOT (G)
This foot permits better control of fabric when doing free motion work.
Raise needle.
Take foot off machine.
Remove presser foot with shank.
Guide Darning and Embroidery Foot
from back of needle, with holding fork (1)
around presser foot screw, and lifting
finger (2) above needle clamp.
Tighten presser foot screw with coin.
To remove, loosen screw; guide foot
back.
ATTACHING FEED COVER (F)
The feed cover keeps the feed from moving the fabric.
Place new foot under center of shank.
Lower presser foot lifter, fitting shank
over presser foot pin (3).
Don’t turn screw. Instead, push presser
foot screw
(4) down
firmly until foot
snaps into place.
Raise needle and presser foot.
Open slide plate.
Slide feed cover on top of needle plate,
pressing tabs (1) and (2) into holes.
Close slide plate.
To remove, open slide plate and lift
front edge of cover; pull it away.
CHANGING THE NEEDLE PLATE (A) (C)
Your machine comes with the General Purpose Needle Plate (A) attached. To attach the
Straight Stitch Needle Plate (C);
Raise needle and presser foot.
Open slide plate.
Lift up needle plate from right corner
and slide out from under foot.
To replace needle plate, slide it under
pin (1) and push it firmly to the left.
Press down until it snaps into place.
11