SINGER 9124 - Manual (Page 9)

WINDING A BOBBIN
The wind-in-place bobbin winds quickly and easily while it’s in the machine.
Raise needle to highest position by
turning hand wheel toward you.
Raise presser foot.
Open slide plate.
Turn pattern selector dial (1) until
indicating dot lines up under Straight
Stitch/Bobbin Winding, (2). (Details on
"Selecting a Pattern" are on page 18.)
Put an empty bobbin, with black rings
(3) facing up. into bobbin case (4).
Close slide plate, lining up marks (5) on
slide plate and machine bed. This
engages the bobbin winder.
If your machine has pop-up automatic
positioning button (6), close slide plate
until it stops against button. This will
automatically engage bobbin winder.
Bring thread from needle, under presser
foot and wind it one turn in any direction,
around presser foot screw (6) pulling it
into groove as shown.
Begin running machine at a moderate
speed.
The window in the slide plate lets you
watch the bobbin winding.
When desired amount of thread has
been wound, stop machine. DO NOT
ALLOW THREAD TO WIND BEYOND
THE OUTSIDE "FULL” RING (7).
Remove thread from presser foot screw.
• Close slide plate, returning machine to
sewing position.
• If your machine has pop-up automatic
positioning button (8) push button down
with your finger while closing slide plate.
• Raise needle to its highest position.
• Pull 4" (10cm) of thread under foot
toward back of machine, and cut.
• To begin sewing, position needle in
fabric where desired, lower presser
foot and start machine.
15