Upper threading, Allt «v zt “t – SINGER W571 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
/ 1
UPPER THREADING
(Fig. 10)
1. Turn the hand wheel toward you to raise the take-
up lever and needle to their highest position.
2. Place spool of thread on the spool pin nearer the
needle.
^
^
3. Lead thread through rear and front arm thread
guides (A).
down and between tension discs B from right to left
up and around into the notch on check spring (C)
over tension discs.
Down under thread guide bar and into guide (D)
up into take-up lever from right to left (E)
8. down through guide (D) in thread bar again
9. into thread guide F)
Fig. 11
10,
through needle clamp guide (G) and into needle
from left to right pulling three to four inches of
thread through needle.
allT «V Zt “T"
.hen irbe tuTed“
uP- A loop will be fo^ed oner the upper .breed „bich
hen can be pulled out straight (Fig. 11), Place both thread ends und.r it,. -x pi.
fnot - J
4.
5.
6
.
7.