SINGER W711 - Manual (Page 43)

FOR PORTABLE INSTALLATION
i:ieas^ read these important instructions
.H.^h were written to aid you in placing your
new sewing machine on its portable base.
First remove the nail which holds the loot
control inside the base to avoid damage m
,hipoina. If a small plastic clamp is fastened
the back and not to the top of the parti­
tion at one end of the base, remove it, too.
After unpacking the sewing machine unit,
being certain to take out the instruction book,
guarantee and accessory box, lay the unit
face dov
7
n on a table. You will see two
clamping screws A entering head hinge holes
on the underside of the back.
Cn the base you will find two head hinges
which v/ill fit into holes B. Lower the base
onto tiie sewing machine fitting hinges C into
holes E. lighten screws A securely with a
screw driver.
With
machine
in
sewing
position attach
plastic clamp D to top o: partition with screw
provided so that it may be turned across tiie
bed o: the machine, to hold it dowit. ^ v'n
some bases the clamp may be positioned m the
proper spot
A
To make the electrical - connection draw
the two wires through the slot in the partition
of the base. Plug the cord labeled "Motor"
into the receptacle marked "Motor" on the
block attached to the outer section of the
base. Then insert the other cord into the
"Light" receptacle.
Place the foot control on the floor, insert
plug into a wall outlet (110-115 volts) and
you are ready to sew. But first read the in­
struction book to become familiar with the
threading of the machine, tension adjustments
and all the other features designed to make
sewing a pleasure.