Upper threading – SINGER W165 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
rtffif ¿BiiSwjC rt»i^JwIifcp^V.j<«a»^-rf-^v«vsj'j ^-»'^
UPPER THREADING
(Fig. 10)
1) Place spool of thread on upper spool pin,
2) lead thread through arm thread guide A
3) down and around tension discs B from right to
left
4) into the check spring C over threaded discs
5) then pull thread under bar D (See insert. Fig.
10
)
6
) up into take-up lever E from right to left
7)
down into thread guide F on face plate
8
) through the needle bar thread guide G
9) and into needle from left to right. Pull three or four inches of
Hold the end of upper thread loosely and turn hand wheel toward you until the needle
goes all the way down and comes back up. A loop (Fig. 11) will be formed over the lower
thread which then can be pulled out straight Place both thread ends under the slot of the
presser foot and draw toward the back of the machine, leaving both threads three or four
inches long.