SINGER W165 - Manual (Page 9)

PLACING BOBBIN CASE IN SHUTTLE
Open, hinged cover plate left of the needle.
(See 11, Fig. 1) Hold the bobbin case latch, (D),
Fig. 9, between the thumb and forefing'er of the left
hand, with at least three inches of thread running
from the top of the bobbin case to the right. Insert
and center the bobbin case on the stud of the shuttle
body, (C). Be sure
0 the bobbin case
^ finger, (E), is will
enter the shuttle
race notch, (A).
Press the bobbin
case (B) into the
shuttle as far as
possible until latch
catches
on the
center post of the
^^9’ 9 shuttle.
THEN release the bobbin case latch, (D).
Press bobbin case again after latch has been re­
leased to make sure the bobbin case is locked
securely in place. Close the cover plate.
Fig, 10