Removing the work, Creative embroidery – SINGER W165 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
14
REMOVING THE WORK
Be sure to stop the machine when the thread take-up
lever and needle bar are located at the highest position.
Now raise the presser foot and draw the fabric back and
to the left. Fig. 21-A and B, and pass the threads over the
thread cutter.
Puli down slightly, holding thread in both hands, so as
not to bend the needle.
Leave the ends of thread under the presser foot.
CREATIVE EMBROIDERY
Be sure zigzag presser foot and zigzag needle plate are
in place.
The satin stitch, Fig. 22,
which is really just a very short
zigzag stitch, and the basis for
Eig.
22
most embroidery, is obtained by setting the stitch length as
near
0
as possible without stopping the feeding action.
The width may be set anywhere from just past 0 to the
widest, 4.
mm
Fig. 21-A
Fig. 21-B