The set of hemmers, Darning spring – SINGER W165 User Manual
Page 35
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
34
THE SET OF HEMMERS
Before attaching any of the hemmers, be sure bobbin
thread is pulled up. Then, with hensmer in place, hold top
thread loosely and turn handwheel one full turn toward you,
making a loop under hemmer. Grasp bobbin’ thread with
both hands and slip horizontally under hemmer toward back.
Bobbin thread will catch loop and carry upper thread to
back of hemmer.
Fold material in 1/8 inch for two inches along edge,
hold at each end of fold. Slip fold into guide and up over
spoon. (Fig. 46). Fold hem in material back of hemmer.
Draw forward to end of hem and fasten with point of needle.
Pull on threads gently as you start stitching.
Fig. 46
DARNING SPRING
HOW TO ATTACH
Remove
presser
foot,
unthread
needle,
place
darner
spring, on needle and slip hook up over hub on needle clamp,
PATCHING AND MONOGRAMMING
See page. No. 18 Fig. 47.