Adjusting cutting width & balance of stitch – SINGER WSL2000 ATS (Part 1) User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ADJUSTING CUTTING WIDTH &
BALANCE OF STITCH
The cutting width can be adjusted from 4mm to 7mm by simply turning the cutting
width dial according to the type of fabric you are working with. This fine tune adjustment
allows you to achieve the best stitch possible on all fabric types.
The normal setting for the cutting width is 6mm.
Adjust the cutting width by turning the dial on the left side of the Superlock. If the cutting
width is narrower than the stitch width, leaving loops off the edge of the fabric, turn the
cutting width adjustment dial toward 7.
If the cutting width is wider than the stitch width causing a pucker within the overlock
seam, turn the cutting width adjustment dial toward 4.
25