Superlock set up & maintenance – SINGER WSL2000 ATS (Part 1) User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

SUPERLOCK SET UP & MAINTENANCE

1. Set your Superlock on a sturdy, flat surface.

2. Your Superlock has been thoroughly oiled at the

factory so be sure to wipe the needle and bed
plate areas carefully before sewing a garment.

Practice on a scrap of fabric so any surplus oil
is absorbed.

3. FOOT CONTROL

Push foot control plug into the connector socket

at the bottom right side of your Superlock.

4. POWER/LIGHT SWITCH

To operate your machine, turn the power switch
on. It is located at the bottom right hand side.
The same switch controls both power and light.

If leaving your Superlock unattended, turn

switch off.

5. OPENING FRONT COVER

To open front cover, push part B of cutter cover
to right and pull the cover down toward you.
To open the side cover, press down on the
silver knob located to the inside of the side cover,
and swing the lower left portion of the Superlock
to the left.

6. CLOSING FRONT COVER

Push part B and lower left cover toward the

center of the front to close it.

Note: Always close front cover when sewing.

7. OPENING SWING-AWAY SIDE COVER

To open side cover, pull the release lever toward
you with your right hand and swing out to left.

NOTE: Always close side cover when sewing.

Connector
socket

Release lever

Swing away
side cover

Advertising
This manual is related to the following products: