SINGER W231 - Manual (Page 10)

Setii4iXf, tlte /Needle
1. Turn the balance wheel toward you. raising needle bar to its
highest position, and loosen the needle clamp screw.
2- Hold the needle in the left hand with the point down, and
insert the needle up into the needle clamp as far as it will go,
with its flat surface to the right; then retighten the clamp
screw (Fig. 14).
Puikh*iiio4t ^nofi ^eed i^eed Paidtla*i Pefulatan.)
The PUSHBUTTON DROP FEED is located on the bed of the machine.
It regulates the position of the feed dog for sewing very thin
material and for darning and embroidering.
1. For sewing very thin material, push down the left side
knob (B) until the red mark line reaches the surface of
the plate.
2. For darning, embroidering and tnonogramrning, push
down the left side knob (B) completely and the feed
mechanism will be lowered under the lever of the stitch
plate, so that the material can be moved freely.
3. For normal sewing, push down the right knob (A) com­
pletely.
(Fig. 15)
Fif. 16