SINGER W231 - Manual (Page 4)

Beudlfiii
I'he lamp housing is located at the front side
of the arm under the arm cover (Fig. 2).
The light switch knob is located at the riglit
side of the vertical arm. To switch on the
light turn the light-switch knob clockwise or
counter-clockwise. To switch off the light
turn the light-switch knob clockwise or
counter-clockwise. In order to replace a
burnt out bulb with a new one, loosen the
two screws on the top of the arm-cover and
remove the cover. Bulbs (15w) may be
obtained at dealers, department stores and
electricals stores.
Sewlight Switch knob Fig. 2
9*ti4kUUHi(^ eMead ¿*tta QaJUaet
1. Loosen the two hinge screws under the holes in the rear
edge of the machine bed. (Fig. 3)
2. Raise hinge pins in the cabinet cutout. Slip machine head
on to the pins and tighten hinge screws securely.
3. Lower machine head to front cabinet flap.