SINGER W231 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BuiioH. Se44MH^
Turn balance wheel toward you to get needle to its highest
position. Raise presser bar and remove regular presser foot,
attach button sewing foot instead, as shown in Fig. 29. Drop
the feed dog as required for darning and embroidering. Upper
and lower thread tensions remain the same as for ordinary sewing.
Place material or garment with button under the presser foot,
so that holes in button line up with oblong hole in presser foot.
Adjust width of zigzag stitch to permit needle to pass through
center of holes in button.
Before sewing with power, turn balance wheel by hand (toward
you) making one stitch into each hole in the button and be sure that needle will not hit
Then sew five to six stitches to attach button.
When attaching four-hole buttons, first sew one set of two holes, then stitch into second
two holes and lock thread with two or three plain stitches in last hole same as described
same.
set of
:ibove.