Placing bobbin case in shuttle – SINGER W1776 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SLOT
Fig. 8
SLOT
Fig. 9
TF.NSION SPRING
F i g . 1 0
PLACING BOBBIN CASE IN SHUTTLE
Raise needle bar to highest position, and slide cover plate
to the left (l6, Fig, l).
Hold the bobbin cose latch, (D,
Fig, 11) between the thumb and forefinger of the left hand,
with at least three inches of thread running from the top of
the
bobbin
cose
to
the
right.
Insert
and
center
the
bobbin
cose
on
the
stud
of
the
shuttle
body,
(C).
Be
sure
the
bobbin case finger, (E), is opposite the shuttle race notch (A).
Press the bobbin case (B) into the shuttle as for as possible
until
latch
catches
on
the
center
post
of
the
shuttle.
Then
release
the
bobbin
case latch,
(D), Press
bobbin
case again
after latch has been released to make sure the bobbin case
is locked securely in place. Close the cover plate.