SINGER W1776 - Manual (Page 9)

UPPER THREADING
1. r„rn ,k,
take-up lever to its highest position.
2. Ploce o spool of threod on the spool pin
4 h I w - ^ top threod guides
pull Z d 'Ti -‘»h 'he right hond.'
pull the end of threod between the tension discs
from right to left.
’
5. Pull the spring wire loop up until the threod
posses beyond the beok of hook to the righf
Aen pul the threod bock to the left, the threod
will be slipped into the hook ond the spring wire
loop will return to position. See Fig. I2-B
6. Up ond through the eye of the toke-up lever
from right to left.
7. Leod threod down through threod guide ot the
lower end of threod guide plate in the slot
the dl 'trough
fhe needle bor guide from the bock
thrl K drowing it
hrough obout 3 or 4 inches. Hold the end of
he upper thread loosely and turn the hand wheel
toward you until the needle goes all the way
S forced '°°P (Pig- '3) wii
be formed over the upper threod which then con
be pulled out straight. Place both threod ends
to dZ -d "ow
toward the back of the machine, leaving both
threods three or four inches long.
f^tg- 12
Fig. 12-B