Pickiimg-up lower bobbin thread, Regulating pressure – SINGER W1220 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PICKIIMG-UP LOWER BOBBIN THREAD
Raise presser foot.
Holding upper thread, turn
hand wheel toward you
one rotation.
When take up lever is at its
highest position, pull thread
to pick up loop of lower
bobbin thread.
Pull both upper and lower three
"to the left of" presser foot ap
proximately
6
inches.
This will prevent jamming.
REGULATING PRESSURE
Fig. 1
Fig. 2
The amount of pressure that is applied to the fabric by the pn
foot is adjusted by the pressure cap (1). The upper position give
least amount of pressure while the lowest position gives maxii
pressure.
To increase the pressure, push down on the pressure cap to o
the desired setting. To decrease the pressure, press down ot
snap lock ring (
2
) to allow the pressure cap to return to its maxn
height. Then reset to the proper pressure.
Normally the pressure cap will be in the lowest position. If th<
layer of fabric tends to push out further than the bottom lay
fabric, Pressure should be decreased. This often happens on 1
fabrics, such as wools, and on knits.
10