To remove the bobbin from bobbin case, To attach the bobbin case, Changing the bobbin – SINGER W1220 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CHANGING THE BOBBIN
TO REMOVE THE BOBBIN FROM BOBBIN CASE:
^°RaiL needle bar to its highest position. Bobbin case cannot b
removed when needle bar is at low position.
Open shuttle race cover, pull bobbin case latch with two fingers an
remove bobbin case as shown above.
Remove bobbin from bobbin case by releasing latch.
TO ATTACH THE BOBBIN CASE:
• Pull thread at least 3 inches from bobbin.
• Thread bobbin as shown on pagef 7 ).
u uu
. Making sure that needle bar is at its highest position insert bobb
case into shuttle race by holding bobbin case latch. Make sore bo
bin case finger is inside shuttle notch. Press bobbin case into shuti
as far as possible until latch catches on center post of the shuttk