Attaching feed cover, Free motion embroidery – SINGER 6412 Millennium User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CHANGING PRESSER FOG
REPLACING PRESSER FOOT WITH SHANK
TO REMOVE-
• Lift toe of presser foot
until it snaps off shank.
• Take foot off machine.
TO REPLACE-
• Center new presser foot
under shank(1).
• Lower presser foot lifter.
• Press presser bar (2) down.
ATTACHING FEED COVER
• Press tab (1) and (2) into holes on
needle plate.
Loosen presser foot screw and
remove foot.
• Hook new foot around presser bar.
• Tighten screw.
FREE MOTION EMBROIDERY
RECOMMENDED SETTINGS
Stitch Selection: Straight Stitch or Zig-Zag
Stitch Width:
D»
Stitch Length: Feed cover
Foot:
Remove foot with shank
Attach feed cover.
Control fabric with embroidery
hoop.(hoop not included).
Lower presser foot lifter.
Lengthen or shorten stitches by
moving hoop faster or slower.
—
10
—