SINGER P-1250 Professional User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
T O W I N D T H E B O B B I N
1. REMOVE bobbin winder pin (A) from accessory tray behind
door.
• PUSH it down firmly in center of hand wheel.
2. MOVE slide cover to the left.
• LIFT foot with foot lever.
• TURN hand wheel clockwise, moving carrier to the far left.
3. LIFT OUT bobbin case from carrier.
4. RE.MOVE'bobbin (B) from case (C).
5. PLACE spobi of thread, with slit on bottom, on spool pin (D)
behind door so thread unwinds from back of spool.
• LEAD thread from spool through back of thread guide (E).
• BRING thread from guide into center hole of slotted end of
bobbin.
• SLIDE slotted end of bobbin over winder pin and PUSH
DOWN into place.
• CUT excess thread from top of bobbin.
• TURN machine "ON" and slowly GUIDE thread up and
down as bobbin winder turns.
• TURN machine "OFF" before thread winds beyond rims
of bobbin.
• CUT thread 3" (7.5cm) from bobbin.
• REMOVE bobbin from winder pin and REMOVE winder pin
from hand wheel.
• PULL center thread from slotted end of bobbin and trim.
• PLACE bobbin into case as follows:
-3-