SINGER P-1250 Professional User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
When it’s lime to change thread:
• TURN hand wheel clockwise until needle is in its highest
position.
• LOWER foot.
• PLACE thread spool, with slit down, on spool pin behind door.
Thread will unwind from back of spool.
• DRAW thread from spool around back of thread guide post
(A).
TO THREAD YOUR MACHINE
• HOLD spool in place; PULL thread between discs from back
to front (
8
).
• BRING thread up through guide (C) from back to front
• Then BRING thread down through needle from front to back,
pulling 3" (7.5cm)'of thread through needle.
To use needle threader (D). first insert wire loop from back of
needle's eye. Place thread through wire loop. Draw needle
threader, with thread, back through eye.
-6-