Placing bobbin case in shuttle, Upper threading – SINGER WS1145 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PLACING BOBBIN CASE IN SHUTTLE
Open bobbin case cover plate left of the needle. (See ®, Fig. 1) See Fig. 10 Hold the
bobbin case latch, (i), between the thumb and forefinger of the left hand with at least ree
inches of thread running from the top of the bobbin case to the right Insert and center the
bobbin case on the stud of the shuttle hook (f). Be sure the bobbin case finger, ® ,
i
opposite the shuttle race notch, ®. Press the bobbin case ® into the shuttle as far as possible
uSl latch catches on the center post of the shuttle. THEN release the bobbin case latch,
Press bobbin case again after latch has been released to make sure the bobbin case is loc e
securely in place. Close the cover plate.
UPPER THREADING
Fig, 10
1. Turn the hand wheel toward you to raise the take-
up and needle to their highest position.
2.
Place spool of thread on spool pin,
3.
lead thread through hole in arm thread guide,
4.
down and around one set of tension discs from right
to left,
5.
into notch on the right hand side of check spring
over threaded discs,
6.
under thread guide bar (®, Fig. 12).