Generac Power Systems GUARDIAN 04137-0 - Manual (Page 5)

Important Safety Instructions
SAFETY RULES
Guardian Liquid-cooled 8 kW Generators
/k ELECTRICAL HAZARDS FIRE HAZARDS
All generators covered by this manual produce
dangerous electrical voltages and can cause fatal
electrical shock. Utility power delivers extremely
high and dangerous voltages to the transfer
switch as does the standby generator when it is
in operation. Avoid contact with bare wires, ter­
minals, connections, etc., while the unit is run­
ning, Ensure all appropriate covers, guards and
barriers are in place before operating the genera­
tor. If you must work around an operating unit,
stand on an insulated, diy surface to reduce
shock hazard.
Do not handle any kind of electrical device while
standing in water, while barefoot, or while hands
or feet'^are wet. DANGEROUS ELECTRICAX
SHOCK my RESULT.
The National Electrical Code (NEC) requires the
frame and emernal electrically conductive parts
of the generator to be connected to an approved
earth ground. Local electrical codes also may
require proper grounding of the generator electri­
cal system.
ATter installing this standby electrical system, the
generator may crank and start at any time vdth-
out warning. Wlien this occurs, load circuits are
transferred to the STANDBY (generator] power
source. To prevent possible injury if such a start
and transfer occur, always set the generator’s
Auto/Off/Manual switch to its OFF position
before working on equipment.
In case of accident caused by electric shock,
immediately shut down the source of electrical
power. If this is not possible, attempt to free the
victim from the live conductor. AVOID DIRECT
CONTACT WITH THE VICTIM. Use a noncon­
ducting implement, such as a rope or board, to
free the victim from the live conductor. If the vic­
tim is unconscious, apply first aid and get imme­
diate medical help.
Never wear jewelry when working on this equip­
ment. Jewelry can conduct electricity resulting in
electric shock, or may get caught in moving com­
ponents causing injun/.
For fire safety, the generator must be installed
and maintained properly. Installation altvays
must comply with applicable codes, standards,
laws and regulations. Adhere strictly to local,
state and national electrical and building codes.
Comply with regulations the Occupational Safety
and Health Administration (OSHA) has estab­
lished. Also, ensure that the generator is
installed in accordance with the manufacturer's
instructions
and recommendations. Following
proper installation, do nothing that might alter a
safe installation and render the unit in noncom­
pliance mth the aforementioned codes, stan­
dards, laws and regulations.
Keep a fire extinguisher near the generator at ail
times. Extinguishers rated JABC" by the National
Fire Protection Association are appropriate for
use on the standby electric system. Keep the
extinguisher properly charged and be familiar
with its use. If you have any question pertaining
to fire extinguishers, consult your local fire
department.
A EXPLOSION HAZARDS A
Do not smoke around the generator. Wipe up any
fuel or oil spills immediately. Ensure that no
combustible materials are left in the generator
compartment, or on or near the generator, as
FIRE' or EXPLOSION may result. Keep the area
surrounding tlie generator clean and free from
debris.
Although using diesel fuel is safer than using gaso­
line or gaseous fluids, which are are extremely
EXPLOSIVE, diesel stiU. presents the danger of
possible FIRE. Install the fuel supply system
according to applicable fuel-gas codes. Before plac­
ing the standby electric system into sertlce, fuel
system lines must be properly purged and lecJt
tested according to applicable code. After installa­
tion, you must inspect the fuel system periodically
for leaks. No lealtage is permitted.
Generac® Power Systiems, inc.