NordicTrack 831.29882 User Manual

Page 25

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

4. SYMPTOM: THE HEART RATE MONITOR DOES NOT FUNCTION PROPERLY

a. See How to Use the CardioTrack™ Heart Rate Monitor on pages 8 and 9. and Pulse Display on page 13.

5. SYMPTOM: THE WALKING BELT IS OFF-CENTER WHEN WALKED ON

a. If the walking belt has shifted to the left, first remove the key

and UNPLUG THE POWER CORD. Using the included alien
wrench, turn the left rear roller adjustment bolt clockwise, and
the right bolt counterclockwise, 1/4 of a turn each. Be careful not
to overtighten the walking belt. Plug in the power cord, insert the

key and run the treadmill fora few minutes. Repeat until the

walking belt is centered.

b. If the walking belt has shifted to the right, first remove the

key and UNPLUG THE POWER CORD. Using the alien wrench,
turn the left rear roller adjustment bolt counterclockwise, and the

right bolt clockwise, 1/4 of a turn each. Be careful not to over­

tighten the walking belt. Plug in the power cord, insert the key
and run the treadmill for a few minutes. Repeat until the walking
belt is centered.

c. If the walking belt slips when walked on, first remove the key

and UNPLUG THE POWER CORD. Using the alien wrench, turn

both rear roller adjustment bolts clockwise, 1/4 of a turn. When

the walking belt is correctly tightened, you should be able to lift
the edges of the walking belt 3 to 4 inches off the walking plat­
form. Be careful to keep the; walking belt centered. Plug in the

power cord, insert the key aind run the treadmill for a few min­

utes. Repeat until the walking belt is properly tightened.

6. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON

a. Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length.

b. If the walking belt is overtightened, treadmill performance may

decrease and the walking.b^lt ma^be permanently damaged.
Remove the key and UNPLUG THE POWER CORD. Using the
alien wrench, turn both rear,j;pjler adjustment bolts counterclock­

wise. 1/4 of a turn. When the' walking belt is correctly tightened,
you should be able to lift the edges of the walking belt 3 to 4

inches off the walking platform. Be careful to keep the walking
belt centered. Plug in the power cord, insert the key and run the

treadmill for a few minutes. Repeat until the walking belt is prop­

erly tightened.

c. If the walking belt still slows when walked on, please contact our Customer Service Department.

7. SYMPTOM: THE SPEED OF THE WALKING BELT FLUCTUATES OR DOES NOT REACH 12 MPH.

a. Make sure that no other appliance is on the same circuit as the treadmill.

25

Advertising