What to do if, The pilot lamps do not show, The oven does not heat – AEG 840E User Manual
Page 52: The fuses keep blowing, The oven lighting fails, The oven cannot be switched on, What to do i f
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Faults
you can rectify
yourself
What to do i f . . .
... the pilot lamps do not show?
... the oven does not heat?
1. You may well have not operated ail relevant switches or
2. the fuse on the fixed wiring side (safety box) has blown.
... the fuses keep blowing?
Please call an approved electrical installer.
... the oven lighting fails?
See Cleaning and care on page 100.
Failure of my oven lamp(s) does not fall under the guarantee.
... the oven cannot be switched on?
Check whether:
... my time of day is flashing 00:00 or 0:00 in the displayl
If yes, reset my time of day.
... the audible tone of my timer is emitting a continuous tone.
Then press the corresponding button to switch it off!
... my timer display does not show, but the pilot lamps of the
appliance still show?
... incorrect indications appear in my display?
... duration and end cannot be entered!
An operating fault has occurred in my timer, or else there has
been a short-term power failure.
Then remove/unscrewthe wiring fuses of the appliance, wait
30 seconds, and then switch on/screw in the wiring fuses
again.
Then reset the time of day in my electronic timer.
104