Installation installation – STIEBEL ELTRON DHB-E 13 SL User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION
INSTALLATION
from behind Into the back panel, to reduce the stiffness or the
grommet.
»Remove the fixing toggle from the upper pnrt of the bnck panel
{diagram "Mounting the appliance’}.
»Route the power cable from behind through the cable grommet
until it rests against the cable sheath. Align the power cable.
If the cross-section of the power cable is greater than 6 mm.
enlarge the hole in the cable grommet (see also "Power supply
for larger cross-sections").
»Push the appliance over the stud of the mounting bracket, so
that it breaks through the soft seal. If necessary pierce the soft
seal with a screwdriver.
»Putthe fixing toggle onto the stud of the mounting bracket that
penetrates the back panel.
»Press the back panel firmly into place and lock the fixing toggle
by turning it through 90“'.
Mounting the appliance
9.4.10 Finalising the water connection
...........
9.4.11 Connecting the power supply
»Connect the power cable to the mains terminal (see chapter
"Wiring diagram').
Earth connection
Ensure that the appliance is connected to earth.
Power connection
SiK-
9.4.12 Fitting the lower back panel
Installing and securing lower part of back panel
9.4.13 Completing the installation process
»Align
the
mounted
appliance
by
loosening
the
fixing
toggle,
aligning the power supply and back panel, and then retightening
the fixing toggle. If the back panel of the appliance is not flush
against the wall, the appliance can be fixed with a screw in the
lower part.
23 I DHB-E ... SiL electronic
vrww.stiebeL-eltron.com